Instructions on how to install welcome car door lights

Installation steps：

1. Use an installation tool to carefully remove the original car door light.
2. Pull out the original door light and disconnect its connector.
3. Prepare the new door projector light and align it with the original light opening.
4. Connect the new projector light to the corresponding connector.
5. Secure the new projector light in the original position and make sure it is properly installed.
6. Turn on the light and test the projection. The logo should project clearly onto the ground. Done!

Installation video：

Q&A：

Question: After installation, the pattern angle is tilted.

Answer:You can rotate the lens to adjust the angle of the pattern.